- Services / Jig & Fixture Design
- Service 05 / 09
Capability
Repeatable operations, designed by someone who's set them up.
Assembly fixtures, weld jigs, and inspection gauges engineered with the ergonomics of the operation in mind, not just the geometry of the part.
Types
Assembly · Weld · Inspection
Analysis
Tolerance stack-up included
Fabrication
Full fab file package
Discipline
Ergonomics + geometry
- What you get
Fixtures a floor operator actually wants to use.
Assembly fixture CAD
Parametric model with locators, clamps, hardware callouts, and clear operator access.
Weld jig design
Tolerance stack analysis, heat consideration, tack points jigs that hold the joint square through the weld.
Inspection gauges
Go / no-go gauges, functional check fixtures, and datum references pass/fail the operator can trust.
Complete fab package
Drawings, BOM, hardware list, and vendor-ready STEP files hand it to your shop and walk away.
- Photo Showcase
Fixtures on the floor.
Welding jig with workpiece clamped
PHOTO SLOT · 16:9 · shop-floor context
Inspection gauge in use (hands + part)
PHOTO SLOT · 4:3
Assembly fixture holding a workpiece
PHOTO SLOT · 4:3
- Who this is for
Anyone repeating an operation more than a few times.
Assembly stations for repeat production
Consistent output when the operation changes hands, changes shifts, or scales up fixtures that enforce the spec.
Weld fixtures for consistent joins
Square joints, repeatable geometry, and jigs that survive the heat. Fewer rework passes, less scrap.
Go / no-go QC gauges
Take subjective judgment out of the inspection loop. Every part gets checked against the same physical reference.
Custom holding fixtures for machining
Odd-shaped parts, second-op setups, and fixtures for parts that shouldn't be in a vise but have to be.
- The Grand Designs edge
The designer has run the operations.
Ergonomics considered, not just geometry
Where does the operator's hand go? What do they see? What has to be reachable with one hand while the other holds a torque wrench? Designed into the model, not discovered on the floor.
Designed to be fixed, not scrapped
Wear items serviceable. Common bushings and locators specified. When something takes damage, you rebuild not replace the whole fixture.
Tolerance stack analysis included
The math is done before the fixture is built not discovered when the parts don't fit.
Repeat operation slowing you down?
Describe the setup. Get a fixture design.
A photo of the current setup and a description of the pain point is enough to start. Full fab package delivered within days for typical jigs.